This functionality is currently only supported in Map Viewer Classic (formerly known as Map Viewer). It will be available in a future release of the new Map Viewer.
The Interpolate Points tool allows you to predict values at new locations based on measurements found in a collection of points.
To run the Interpolate Points tool, your portal's hosting server must be licensed with an ArcGIS Server Advanced license.
A GIS analyst has a dataset with elevation points across the state of Oaxaca, Mexico. Interpolate Points can be used to predict elevation values across the state to create an elevation surface.
A point layer is used as the input. The input layer must have a numeric field to serve as the basis of the interpolation. Interpolate Points is designed to work with data that changes slowly and smoothly over the landscape, such as temperature and pollution levels. It is not appropriate for data such as population or median income that changes very abruptly over short distances.
The Interpolate Points tool can be set to optimize speed or accuracy, or a middle ground. The more accurate the predictions, the slower the results take to calculate and vice versa.
A layer of standard errors can be created by checking the Output prediction errors box. A 95 percent confidence interval can be calculated for the interpolated layer by taking the interpolation value and adding two standard errors for the upper limit and subtracting two standard errors from the lower limit.
Clip output to
An area from a layer or the draw tool can be used to specify an area of interest. The interpolation will be performed and clipped to the boundaries of the area.
The classification scheme used to display the resulting density layer. Options include Geometric Interval, Equal Interval, Equal Area, and Manual. If Manual is chosen, you must supply your own class break values, and the Number of Classes parameter will not apply.
Number of classes
The number of classes to be used in the result layer. Used with the classification scheme in the Classify by option.
Predict at these locations
Points can be drawn or provided from a layer so predictions can be made at specific locations of interest. The predictions will be written in an output point layer.
If Use current map extent is checked, only the features in the input point layer within the current map extent will be interpolated. If unchecked, all features in the input point layer will be interpolated, even if they are outside the current map extent.
The Interpolate Points tool can be used on point features only.
When you use the Clip output to and Number of classes parameters together, it's possible to end up with fewer classes than specified. To avoid this, you can run the Find Existing Locations tool first to select points within your area, and then run Interpolate Points on the result.
How Interpolate Points works
Interpolate Points uses the Empirical Bayesian Kriging geoprocessing tool to perform the interpolation. The parameters that are supplied to the Empirical Bayesian Kriging tool are controlled by the Optimize for parameter. The parameters are outlined below.
Data transformation type
Semivariogram model type
Maximum number of points in each local model
Local model area overlap factor
Number of simulated semivariograms
Use Interpolate Points to predict values based on point measurements. Other tools may be useful in solving similar but slightly different problems.
Map Viewer Classic analysis tools
If you are using point or line measurements to create a density map, use the Calculate Density tool.